Warmwire Heated Floor Jun 03, 2016

I installed a WarmWire heated floor in a 6'x8' coat room that had no other source of heat. It is on a concrete slab with 2 outside walls and a wall to an unheated attached garage. I glued 2 6mm thick sheets of Cerazorb synthetic cork directly on the concrete. It was super easy to lay the wire on top on the cork using the metal clip system provided. To be safe, I laid a sheet of 1/4" luan plywood on top of the wires while laying the tile. I checked the resistance in the wires at each step... more

Easy Installation Oct 15, 2016

As a residential service company we take pride in our work and choice of equipment we use. The name Weil McLain has been spelling quality for years before I thought of being a plumber. Just follow the installation instructions and you have heat. My technicians make your boilers look like a piece of artwork.

Plenty Of Hot Water Dec 06, 2016

Easy to install and connect. In hybrid mode made hot water very fast. Warm water with 20 minutes on initial start. You can hear the compressor and fan run so install in an area where the fan noise will not bother you. Very happy with the first week of operation.

As Promised May 10, 2016

Purchased it, it was as promised, delivery was great. Works well. Thanks.

Perfect Unit! Basement Now Under Control Dec 13, 2016

I deep researched this unit before purchasing, previously had small portable units (worked, but labor intensive)...basement would always be 15 percent higher humidity than upper house (deep summer would yield 70 percent humidity downstairs)...I "rafter" hung unit with run off directly to my furnace's evaporation pump (used clear tubing to see water discharge)...as "summer" just arrived and downstairs was reading 56 percent humidity I set unit to 50 on control and 11 hours... more