A Great Little Fan Sep 04, 2016

I bought this in-line fan to pump warm air into a chase containing hot and cold water pipes. When outdoor temperatures drop below 15 degrees Fahrenheit, the air in the chase falls below freezing, so I was worried that the pipes would freeze. This little fan together with flex duct (I stripped away the outer insulation) solved the problem. I have a thermostat in the chase and a control system that turns on the fan when the chase temperature drops below 40 degrees F. Now I can spend time... more

Warmwire Heated Floor May 28, 2016

I installed a WarmWire heated floor in a 6'x8' coat room that had no other source of heat. It is on a concrete slab with 2 outside walls and a wall to an unheated attached garage. I glued 2 6mm thick sheets of Cerazorb synthetic cork directly on the concrete. It was super easy to lay the wire on top on the cork using the metal clip system provided. To be safe, I laid a sheet of 1/4" luan plywood on top of the wires while laying the tile. I checked the resistance in the wires at each step... more

Great Product! Feb 16, 2016

Easy to install!!!

Runtal Uf - 2,325 Btu - Hydronic Baseboard Radiator - 12" H - 30" W - 2" D Review Jul 01, 2016

Expensive but is a nicely manufactured product.

Owner, Custom Made Sep 25, 2016

I replaced a Dunkirk XEB-3 (20 yrs. old) with the Dunkirk boiler above. The new one is all most identical to the old one, that is the pipes were located same as the old, so gas and water lines were easily plumbed. The old electrical wires could be used although lengthened to connect to the digital controls. The circulators location has changed, it's still provided with its wiring provided. Venting is the same as the old one. I was happy to get another Dunkirk that installed easily.